Lithium Ion, Lithium Polymer Battery Charger, 1.3A

• Medical approved (EN 60601)
• 3 step charge control
• Current detection as charge termination
• Switch mode charger with universal input voltage
• Charges 1 to 7 cell packs
• Protected against reverse polarity and short circuit
• LED status indicator
• Custom specifications on request

Input rating: Nominal 90-264VAC/47-63HZ
Cell count: 1-7 cells
Switch frequency: ≈ 40kHz
Leakage current from battery: ≈ 0
Operating temperature: -25°C - +40°C
Ripple: < 100mVp-p
Insulation class: Class II
Insulation voltage: 4000VAC (primary) / 5640VDC (secondary)
Electrical safety approvals: UL 60601-1, EN 60950, EN 60601-1, EN 60335-2-29
EMC standards: EN60601-1-2 (Medical), EN 61000-6-3 (Emission), EN 61000-6-1 (Immunity)
Reliability (MIL-GDBK-217F): MTBF > 250.000 hours at 30°C and full load
Input connection:2 pin IEC 320-C7 (input cordset not included)
Output connection: 2.5mm x 5.5mm x 9mm barrel plug, center positive
Dimensions/weight: 3.55" x 1.77" x 1.26" (90 x 45 x 32mm)/0.25 lbs. (115g)

Once the charger is attached to a lithium ion battery and then plugged in, the charging process will begin. The charger will subject the lithium ion battery to three steps of charging.

During the first step, the charger enters into 'fast charge' mode. During this step, the charger is in constant current mode with the current rate remaining at its maximum rating.

In step two, the battery will be nominally 80-95% charged, and the charger switches into constant voltage mode (current is no longer being provided at its maximum rate). The charger will continue to provide a constant voltage until the charge current decreases to the charge termination level.